Solved: RUCKUS Forums - Where to find R560 Standalone Firmware? - Page 2

Walvoil · ‎07-21-2025

I bought a single R560 for a SMB and I'm running into a bit of an issue. The R560 is going to replace our R510 WAPs which were on the Unleashed platform.

I was planning on this R560 to be standalone, and I upgraded the firmware to 118.1.0.0.1098, however despite it saying it's the standalone firmware, the 560 is Changing all of my radio channels to SmartSelect and I can't change it. It also disables HTTPS/HTTP for the GUI when I update the firmware.

Does anyone have an idea on where I can get the Standalone firmware for this model that doesn't have Unleashed, or SmartZone?

TIA

vasanth_edward · ‎07-22-2025

Hi Walvoil,

Thank you for sharing the requested information.

From the CLI output, I have observed the following:

The AP is not managed by any controller (Unleashed Master, SmartZone, ZoneDirector, or RUCKUS One), confirming that it is operating as a stand-alone unit.
The AP is powered with insufficient PoE. As per the R560 datasheet, the minimum power requirement is 802.3at. You may refer to the datasheet here:
https://www.ruckusnetworks.com/globalassets/digizuite/961313-ds-ruckus-r560-pa-117124-en.pdf (Page 5).

To proceed further, please share the CLI output of the following commands:

get power-mode
get wlanlist

If the output of get power-mode appears as below:

rkscli: get power-mode

PoE Configured Mode : Auto

Power Consumption Status : 802.3af Switch/Injector

USB Status : Disabled

Controller Discovery : Disabled

OK

Then, please enable LLDP on the switch port where the AP is connected and hardcode the power mode on the AP using the following command:

set power-mode at

Kindly share your observations after applying these changes.

View solution in original post

vasanth_edward · ‎07-23-2025

HI Walvoil,

Thank you for the update!

I'm glad to hear that enabling LLDP and adjusting the power mode on the WAP resolved the issue. Appreciate you taking the time to verify the port settings as well.

Please feel free to reach out if you have any further questions or need assistance with anything else.