Unleashed VLAN on WLAN :)

[filip_stokkelan]

Hi!

(I'm not sure about policy for reviving old threads, so instead of replying to this old thread, https://forums.ruckuswireless.com/conversations/ruckus-icx-switches/ruckus-unleashed-vlan-setup/5f91..., I'm starting a new. Feel free to move it, if that's better.)

I'm new to Ruckus, just got my hands on a ZoneFlex R510.

It's running Unleashed and I'm trying to figure out if I can fit it into existing VLAN structure.

From the above mentioned thread/topic, it seemed it should work if I;

- Connected ethernet (Port 1 or 2) to a switch port configured to delived admin VLAN untagged and the other VLAN's tagged

So I did/tried to do this, and the Ruckus AP gets an admin IP on the network interface, so far so good.

Then configuring the SSID, I enter Advanced, then WLAN Priority and then enter my office VLAN number in the Access VLAN field.

Then it does not seem to work. (I get no DHCP offer through to my client on that WLAN.)

Something I'm missing?

How/where to debug?

My switch is a non-Ruckus switch, configured to deliver admin VLAN as untagged/PVID and three other VLANS as tagged to the Ruckus AP.

(If unleashed is not really up to VLAN'ing, should I use other firmware? What software/hardware/licence is required to manage this in another fasion/way?)

EDIT:

As it seems, just after posting, I realized the switch port (with it's ingress filtering on) was set to admit only untagged and priority tagged. As soon as I switched it to admit all it started working. 🙂

[eizens_putnins]

Most advanced RF settings are available mainly from CLI both in unleashed and standalone mode, SZ and ZD provide more detailed control, but still some things need to be done on AP through CLI.

But you really rarely need them (mostly only to fix some specific issue or in a very specific environment).

[filip_stokkelan]

Ah, there's a CLI, thank you! 🙂