NOTE: The PoE switch port must run link layer disco very protocol (LLDP) power over Ethernet/MDI (PoE+) in order for the R730 to operate in full-power mode. This may require enabling both LLDP and Power via MDI (dot3) on the switch, if available.
Ruckus PoE+ injector: 902-1170-XX00 You can also use the high power (60W) Ruckus PoE injector 902-0180-XX00
You can verify the power delivered to the AP using the following AP command:
rkscli: get power-mode
I hope this is helpful,
Thanks for choosing Ruckus Networks, now part of Commscope