Unable to enable Ethernet Port1 on R730 standalone

[sathish_kumar_k]

Configuration >> Ethernet Ports >> Enabling  Port 1 shows parameters saved, but still the check box is unchecked. 

[albert_pierson]

Hi Sathish,

For the R730 Lan1/Port1 port to work the AP must be powered by PoE+ (802.3at+ 35W (high Power) and the Ethernet port will need LLDP enabled so the AP negotiates the power.

From the quick start guide: https://support.ruckuswireless.com/documents/2443-ruckus-r730-ap-quick-setup-guide-qsg

NOTE:
The PoE switch port must run link layer
disco
very protocol (LLDP) power over Ethernet/MDI
(PoE+) in order for the R730 to operate in full-power
mode. This may require enabling both LLDP and
Power via MDI (dot3) on the switch, if available.

Ruckus PoE+ injector: 902-1170-XX00
You can also use the high power (60W) Ruckus PoE injector
902-0180-XX00





You can verify the power delivered to the AP using the following AP command:

rkscli: get power-mode

I hope this is helpful,

Thanks for choosing Ruckus Networks, now part of Commscope

[sathish_kumar_k]

Thanks for the info Albert. I have Tenda TE-POE30G-AT Gigabit PoE Injector(802.3at) which is only 30W