This website uses cookies. By clicking Accept, you consent to the use of cookies. Click Here to learn more about how we use cookies.
Accept
Reject
RUCKUS Self Help |   ASK the Pack
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 

Ruckus R610 not getting enough power warning?

Go to solution
bdillard
Contributor II

‎03-03-2021 12:12 PM

Not enough power provided - it's capabilities are downgraded. 

We have an unleashed network with all R510's except for one R610.    They are all plugged into POE only.   We have switched out the cables with brand new 6a cables and it still says not getting enough power.   I don't see anything in the unleashed software to adjust much on the AP directly.   It is on version 200.8.10.3.278.   

I saw some mention on another post about turning off usb or switching the power consumption mode but I'm not sure where to do that.

We got a POE+ injector just in case but it still says not enough power.

0 Kudos
1 ACCEPTED SOLUTION

Go to solution
bdillard
Contributor II

‎03-03-2021 02:16 PM

So I found the solution.   

  1. Go to the unleashed web interface for your APs.  
  2. Select Access Points
  3. Select the R610
  4. Go to Edit
  5. Go to the last tab - Other
  6. Last menu item - Override Group Config
  7. Select 802.3at POE
  8. Click OK
  9. Wait for it to reboot or reboot if it doesn't on its own.

While that wasn't that bad to do, I think the next unleashed firmware update should include the intelligence to say - if you are above an R510, auto select 802.3at POE.

View solution in original post

3 REPLIES 3
Copyright © 2024 Khoros, LLC