Reprogramming Ruckus H350 Access Points version 901-H350-US00.

[hp7593]

This was the method I used to reprogram the firmware: 

Firmware used for XX = 116.0.0.0.3128_H350.bl7

It's very important to set up the network on the notebook first.

1. Windows Key -> Network status à Ethernet Settings – Select wired network. -> Change adapter options -> Select network -> R-click + Properties -> Double click Internet Protocol Version 4 (TCP/IPv4) -> select Use the following IP address on notebook. -> IP address = 192.168.0.2 -> Subnet mask = 255.255.255.0 -> Nothing for DNS server. -> Press OK.

1. Connect the Ruckus AP directly with a POE injector; one end goes into the Ruckus AP, and the other end into the network-attached notebook.

1. Wait till the Ruckus AP CLT light blinks.

1. Press and hold “Hard Reset” for 15 seconds.

1. Wait till the Ruckus AP CLT light blinks.

1. Press and hold “Soft Reset” for 15 seconds.

1. Wait till the Ruckus AP CLT light blinks.

1. May need to use Private Browsing or Incognito on Firefox or Chrome.

        Open Firefox and type in 192.168.0.1

1. This will log into the Ruckus AP. User = super PW = sp-admin

         Once inside the Ruckus AP, follow the prompts to set up the AP.

1. If AP does not connect, press Hard Reset on AP and try again.