Related to the Unleashed Configuration of Other Models.

[coraise]

HI!

We are going to mix and configure Ruckus R610 and R650.
There is no controller, so I'm going to proceed with the unleashed configuration.

If there is a controller, I know that it is possible to mix other models. in Unleashed, but I would like to know if it is possible to mix models if it is configured as Unleashed.

Thanks!

[DarrelRhodes]

Hi Coraise,

Yes, it is absolutely fine to mix and match AP models in Unleashed.

You need to be aware that this can be complicated if you are attempting to mix older and newer AP models as they will likely need different firmware levels. However both R650 and R610 currently support the latest Unleashed firmware, so you will be good to go!

Hope that helps,
Darrel.

[Vineet_nejwala · Accepted solution]

Hi @coraise 

Yes you can configure Unleash in your network as single system using R650 and R610 AP's. Both these models are supported on the latest code too. Below is the latest 200.12 RN and supported AP in this release :

https://support.ruckuswireless.com/documents/4163-ruckus-unleashed-200-12-mr1-release-notes

Best Regards

Vineet