Hi Mark,
Are you sure that you are following hard reset procedure correctly?
Here is the correct procedure, just in case you want to review.
- Power up the AP.
- Push and hold the reset button for 12 seconds and then release the button.
- Wait for few minutes and let AP factory reset >> boot-up with default settings.
- Check in your DHCP server IP lease table if AP got the IP or not. In case DHCP is not supported in your wired network then connect a laptop to the same switch where AP is connected and then assign the IP 192.168.0.x/24 (other then .1 you can assign any IP) and then try to access AP.
By the way, why you are not using Unleashed for these 4 APs, as it will be much easier for you to manage them with Unleashed.
Regards,
Syamantak Omer
Regards,
Syamantak Omer
Official Rep | Staff TSE | CWNA | CCNA | RASZA | RICXI