R600 unable to find vSZ controller
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-08-2018 02:33 AM
Hello,
I have read through this link https://forums.ruckuswireless.com/ruckuswireless/topics/connect-r500-ap-to-cloud-vsz and made some changes that are described by Dionis, AlphaDog however am still unable to find my smartzone controller with my R600 access point. Other AP's such as the R610 and H320 are fine at discovering the vSZ using the command set scg ip x.x.x.x however the R600 doesn't have this command so am using set director ip x.x.x.x with no luck. discovery-agent is enabled on the AP.
I am a bit stuck as to what to do so any help would be greatly appreciated.
Thanks
I have read through this link https://forums.ruckuswireless.com/ruckuswireless/topics/connect-r500-ap-to-cloud-vsz and made some changes that are described by Dionis, AlphaDog however am still unable to find my smartzone controller with my R600 access point. Other AP's such as the R610 and H320 are fine at discovering the vSZ using the command set scg ip x.x.x.x however the R600 doesn't have this command so am using set director ip x.x.x.x with no luck. discovery-agent is enabled on the AP.
I am a bit stuck as to what to do so any help would be greatly appreciated.
Thanks
9 REPLIES 9
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-08-2018 03:56 AM
pls confirm software version on the R600 AP. I believe you got the incorrect software version...
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-08-2018 04:07 AM
Hi its...
rkscli: get version
Ruckus R600 Multimedia Hotzone Wireless AP
Version: 100.0.0.0.127
OK
rkscli: get version
Ruckus R600 Multimedia Hotzone Wireless AP
Version: 100.0.0.0.127
OK
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-08-2018 04:14 AM
This is controller settings that might be relevant...
LWAPP2SCG Configuration
--------------------------------------------------
ACL Policy : Accept all
Dynamic Data Transmission Port Range : Not specified
NAT IP Translation in FTP Passive Mode : No
ACL APs
LWAPP2SCG Configuration
--------------------------------------------------
ACL Policy : Accept all
Dynamic Data Transmission Port Range : Not specified
NAT IP Translation in FTP Passive Mode : No
ACL APs
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-08-2018 04:15 AM
also i disabled the passive mode and wondering if that is less secure.
Thanks
Thanks