cancel
Showing results for 
Search instead for 
Did you mean: 

Power problems

yorgo_xudous
New Contributor II
Hi, I have 6 unleashed R710s. I just upgraded to 200.8 because I am trying to solve slow speeds on the 2.4 ghz band. After upgrading, I now have an exclamation point remark next to each AP stating that its capabilities are reduced because it is not being provided enough power. This occurs wether I power them through my Mikrotik CRS328-POE or UnifiSwitch24Port-250W. Both of these switches are advertised as being able to provide 802.3at. Is it normal that these switches can't fully power the R710 or is it a firmware problem? 
6 REPLIES 6

yorgo_xudous
New Contributor II
M Miller are you getting 330 mbps on 2.4ghz or on 5ghz?

rob_m_istij3wx4
New Contributor III
5ghz