Not enough electricity power provided with AP warning ?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
01-22-2020 02:51 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-12-2020 10:13 AM
An attached Ruckus AP will sometimes come up with 802.3at enabled, so I would imagine the negotiation must sometimes be successful. (See details above.) Again, I can't rule out a problem with the switch, but perhaps Ruckus unintentionally broke some aspect of their Power Via MDI implementation? Unless Ruckus added the alert for an AP operating at reduced power capacity in an update and I just missed APs operating in 802.3af mode previously, this was definitely working reliably when I first installed the R720s.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-12-2020 10:15 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-12-2020 10:32 AM
I'll attempt when I have some time, though I can't guarantee I'll come up with anything. Netgear did indicate that they planned to do some further investigation after failing to resolve the issue in my ticket, so if it is an issue on their end, hopefully a fix is in the works.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
03-20-2024 01:56 AM
did it through my zd1200 - works perfectly (just overrule group config)
Thanks for the advice!
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
08-08-2021 10:50 PM
I have the same issue. The issue started after updating the unleashed to 200.10 firmware. The issue is on the unleashed firmware 200.8 to 200.10. on the firmware 200.7 didn't get the warning of "Not enough electricity power provided with AP".
Tried several PoE switches and PoE injector but it doesn't resolve. only after downgrading the unleashed firmware to 200.7 its getting resolve. pls suggest.