Showing results for 
Search instead for 
Did you mean: 

How to add additional unleashed device ?

New Contributor II
I have 2 R310 devices in office.
Both was working fine.

I upgrade both to
Master was upgrade successfully but another one was fail.

I see slave device was disconnected in dashboard. OMG!

I upgraded slave R310 to manually but still disconnected.
I removed it from dashboard then reset but still can't map the mesh network automatically.

It always in normal unleashed setting page.
How could I do?

Re-create mesh network?

I will add other one R310 into mesh network in few month.
I need re-create again at that time?

Image_ images_messages_5f91c400135b77e2479124d9_82d5cfabc196f33be0e5eedf047d8a19_RackMultipart20190318161991uab-2d679c55-0cc4-4ada-8ceb-187adead6d70-595700273.PNG1552886160


Valued Contributor
When AP do upgrading, Mater send URL to the AP to upgrade.

Thus the AP have to configure DNS IP.

First please confirm about it on another AP.

I already done DNS setting when I done the unleashed setting 1 year ago.
I remote in dashboard by master device IP then use dashboard upgrade bottom to do upgrade.
After upgrade done, dashboard say slave device upgrade fail and disconnect.

I reset all of three device to make them in a unleashed group.