I've just gotten a Zone Director 1200, and 20 R510's. I have (my "old" WAP's) 15 7363's that I'm replacing. Problem is, the ZD 1200 "grabbed" the 7363's (yes, I went through the setup a little too fast, without enough reading comprehension... my fault entirely!). Now I find myself in a bad spot!
The ZD 1200 firmware version will allow managing the 7363's, But NOT the R510's. If I update the ZD1200, I will be able to manage the R510's, but NOT the 7363's!
This makes a nice orderly installation of the new R510's problematic.
I'd LIKE to "release" the 7363's back to being "stand alone" WAP's (which they were before I turned on the ZD 1200, and clicked "OK, sure, capture them all and make them your slaves...".
Being as how these 7363's are in eight different buildings, I would PREFER not having to go "hands on" on all of them, but if I need to climb ladders, I'll climb ladders!
I have tried "deleting" the 7363's in the Configure-Access Points section of the Zone Director... but, they just sit forlornly blinking their DIR light, through reboots, etc.
I must just be missing something in the Zone Director that says "I release you from my service...".
Tips most gratefully welcomed!
Paul F.
School IT Lackey
