E510 Ethernet Adapter

[robert_navarro_]

Hello,

Does anyone know what kind of ethernet adapter/cable I need to POE power my E510?

From the little bit of tech docs I've found that the connector on the device is a M12 Connector (X-coded, 8 position, Shielded, Female)

But I can't find any cables that will fit.

pinging @DarrelRhodes since you helped with a different obscure E510 question.

 

[DarrelRhodes]

Hi Robert,

Thanks for looping me in.

As you've identified; you need a standard CAT5e (or better) cable, with an 8-core, X-Coded, M12 connector. 

These aren't exactly custom-made, but they are certainly specialist 'industrial grade'! 

Here's some online examples (you must verify these are applicable): 
Farnell: https://uk.farnell.com/metz-connect/142m2x15020/sensor-cable-m12-plug-8pos-rj45/dp/2442829?

RS: https://uk.rs-online.com/web/p/sensor-actuator-cables/2080551

Amazon (multiple lengths available): https://www.amazon.co.uk/Industrial-Machinery-Ethernet-Shielded-Waterproof/dp/B08DF5GZ87/

Please also use the E510 AP module Quick Start Guide as an important reference: https://docs.commscope.com/bundle/E510-QSG-800-71577-001-RevD/resource/E510-QSG-800-71577-001-RevD.p...

I hope that helps,
Darrel.

[KGBC4008]

Hi Darrel - the information is really helpful. Do you have any similar information with respect to sourcing generic control cables to connect E510 access points to their external antenna? 

[Kiran_Raval]

Hi KGBC4008,

The antenna cable part number is available in the AP datasheet. Please refer to the 'Optional Accessories' section in the datasheet at the following link: https://webresources.ruckuswireless.com/datasheets/e510/ds-ruckus-e510.html

Additionally, you may find useful setup information in the Quick Setup Guide: https://webresources.ruckuswireless.com/datasheets/e510/ds-ruckus-e510.html

Regards:

Kiran Raval

[KGBC4008]

Thanks for the super fast reply - i have been unable to trace a source of the ruckus cables perhaps because the product is eol. It does say on the documentation that is is possible to use 3rd party cables so i was wondering if the pinouts are based on a standard which can be sourced from the generic market. Appreciate any guidance you can provide. Many thanks!