cancel
Showing results for 
Search instead for 
Did you mean: 

Can't Rejoin WAP to ZDirector after Factory Reset

chad_seymour
New Contributor
I have a ZF R300 WAP that is currently on my network and I can SSH into the WAP. This WAP was previously connected to our company's Zone Director with a different IP. I have reset the WAP to factory, Uploaded the latest firmware, but when I go to SSH into the WAP and use the CLI Set Director IP X.X.X.X it says "Command is not recognized". Is this because the WAP is saved on the Zone Director still? How do I get the WAP to accept the command.
3 REPLIES 3