Another - not enough electricity power’ question

[Richard_NZ]

I have a R710 and a R650 connected to a TP-Link PoE switch SG1016PE.

The Unleashed gui tells me that ‘not enough electricity power’. It was all good before a power outage and now I get that plus the wireless speed in the house had dropped dramatically. I have read I have to switch from auto to 802.3at but I have no clue how and where to try that? Can anyone help with this please.

[Vásquez_Fer · Accepted solution]

Hello  Richard_NZ , 

You could try manually setting the PoE for the access points to the maximum power that the switch can provide to ensure compatibility.

Video Link : https://www.youtube.com/watch?v=hnpSEut96iw

check the Below link :

AP Power Warnings

Link : https://docs.commscope.com/bundle/unleashed-200.15-onlinehelp/page/GUID-E471A9AF-2F43-4DA4-9A12-8A9B...

Power Limitations by PoE Mode and AP Model

https://docs.commscope.com/bundle/unleashed-200.15-onlinehelp/page/GUID-12E6EFCF-E117-47FA-9D07-FE2E...

[Richard_NZ]

• I have read I have to switch from auto to 802.3at but I have no clue how and where to try that?

Ok - I found a way to do that by following the above advice. Thank you. Now the orange warning triangles have gone. I still have issues and I'll post these in another topic.