I am testing a ruckus 510 in standalone
mode V: 220.127.116.11.469 I have managed to
set it up fine, plugged into a POE switch and it works great with one cable as
soon as I plug a 2nd cable in I cannot connect to the AP from any wireless
device. Both Ethernet ports are enabled and set up the same
It sounds to me that you expect the interfaces to support Link Aggregation. Not all of our APs support this feature. Only the high end APs support this today. Make sure your AP model supports it and make sure the switch it is connected to is also set up correctly for link Aggregation.
The 2nd cable was connected to the same switch, so I assume I was causing a loop on the network. Ok for some reason thought they did. cheers for looking into it and your quick response was driving me mad last couple of days!