CommScope RUCKUS Community Forums

erik_farey · 11-11-2014

I have a ZF7372 running 9.8.1.0.101 and trying to find out how to enable band-balancing via its CLI. I am not running the AP with a ZD as it is a stand alone device. I see the CLI for band-balancing but am not sure how to enable or configure it. I...

erik_farey · 03-04-2015

BUMP.... Anything new on this? Still having the same issue.

erik_farey · 02-18-2015

This is getting more confusing. I have a 7372 running 100.0.0.128 now and don't even see the CLI commands for the band-steering. I have looked at every command in the CLI and don't see anything about band-steering. I don't want band-balancing on a...

erik_farey · 02-15-2015

I might have to start this dialog over again. I have been pulling apart the CLI for a while now and am only having issues with two items, Band-Balancing and Band-Steering. From what I get out of this thread Band-Balancing is configured with the "se...

erik_farey · 02-12-2015

I was wondering if there was any update on this. I can see where .128 is now out. Last Michael Brado was looking into this.

erik_farey · 01-15-2015

I have loaded 100.0.0.0.127 on my test AP. When I run help in the CLI neither band-steering or withholding-limit show. I am able to run the commands though via the CLI. When I do run them via CLI they give me the below: rkscli: get band-balancing...

CommScope RUCKUS Community Forums

User Statistics

User Activity

Stand alone AP (ZF7372) and band-balancing

Re: Stand alone AP (ZF7372) and band-balancing

Re: Stand alone AP (ZF7372) and band-balancing

Re: Stand alone AP (ZF7372) and band-balancing

Re: Stand alone AP (ZF7372) and band-balancing

Re: Stand alone AP (ZF7372) and band-balancing