CommScope RUCKUS Community Forums

harri_waltari · 09-16-2019

I need to check the load balancing mode of the lags on the physical switches (ICX6610, 08.0.30t) facing our esxi cluster. On the cluster side, at the virtual switches, the balancing mode is currently "Source and destination IP address". The manual is...

harri_waltari · 09-23-2019

Vu, Thanks for you informative input. Really appreciate it. I think i get it now.

harri_waltari · 09-19-2019

Hi Vu, I'm thinking the returning traffic. Say, from the host the traffic is sent out via one interface and the return traffic is sent from the switch to the host via another interface because of different load balancing mechanism. And of course vice...

harri_waltari · 09-18-2019

Simon,I understand. Thanks for your input.

harri_waltari · 09-18-2019

Simon, thanks for this. It really clarifies a bit.So, if the mode in the switch is fixed to "Source and destination IP addresses, and source and destination TCP/UDP ports" and the modes available on the vsphere are (amogst others) "src and dst ip add...

harri_waltari · 09-16-2019

Simon, thanks for your prompt response.What you would see what is the correct or most proper setting then on the cluster side? And would you please open the difference btw "bridged tcp/udp" and "bridged ipv4 tcp/udp"?

CommScope RUCKUS Community Forums

User Statistics

User Activity

load balancing mode of a LAG

Re: load balancing mode of a LAG

Re: load balancing mode of a LAG

Re: load balancing mode of a LAG

Re: load balancing mode of a LAG

Re: load balancing mode of a LAG