CommScope RUCKUS Community Forums

istvan_nemeth · 12-05-2016

Hi Guys!I'd like to know, how can I migrate the APs from temporary controller to the final one.Every controller will have public IP address without any restriction between them.The situation briefly, there is an 90day temporary instance which current...

istvan_nemeth · 01-21-2017

HI Eizens,Thanks for share your experiences, this is very valuable information for other members as well. Yes, I already applied similar-like solution like yours, I really like vSZ flexibility/scalability however in this case this way was not applic...

istvan_nemeth · 01-05-2017

I could do it, basically it was a mistake, you have to define your Radius servers under config-system-services-AAAonce it done, you must assign one or more for every non-3gpp auth-method for "No match" and "unspecified" as well (might be you should u...

istvan_nemeth · 12-15-2016

bad approachyou should use NPS instead of native AD authentication via landing pageconfigure properly CA/NPS setting and use it.two advantages:more reliable/secure (WPA2-Enterprise instead of open or static PSK-based WLAN)more easier

istvan_nemeth · 12-06-2016

Hi Michael!Thanks for the hint, so for other membersyou have to login via ssh to your AP (this can be done using credentials what you already set under Zone configuration)once you logged in you have to set the new ip controller address or addresses u...

istvan_nemeth · 11-25-2016

i dont recommend to use over 80m+ even if you're using good quality cables

CommScope RUCKUS Community Forums

User Statistics

User Activity

temporary vSZ to final vSZ migration (in production environment)

Re: temporary vSZ to final vSZ migration (in production environment)

Re: Could Vsz enable to AAA proxy-mode for 802.1x?

Re: AD Authentication

Re: temporary vSZ to final vSZ migration (in production environment)

Re: what is themaximum cable length for POE for accesspoints R600 &R 710??