CommScope RUCKUS Community Forums

try to see the event or alarm under Admin->Diagnostics, what happens about the issued R510.    or set factory the issued R510 and let it join again.

  May 13 17:49:31 Ruckus-Unleashed-dComm stamgr: stamgr_lwapp_upd_pcy_timeout(): handle=16252 ,retry_count = 4 ,re-transmit pcy_id:1, intl_id=0, type=1,op=2  exceed 3 times ,reset ap:f0:3e:90:19:6a:20

it's more likely power issue when with a lot of clients and traffic, as T710 need connect supported 802.3at PoE mode switch, if power is not enough for 4x4 traffic stream, it will reboot. so pls save a debuginfo attached here if the issue happen agai...

please check your DNS configuration firstly, and also check Unleashed dashboard of internet status if it's connected state.

Hi Edward,   after convert to Unleashed image from solo at the first time, you need to do set factory to AP, you can set factroy via hard reset button or CLI command.  hope it will help you.ThanksKim