cancel
Showing results for 
Search instead for 
Did you mean: 

ZD3000 a reduntaste are. I have a ZD3000, Feilover

dauris_reyes
New Contributor II
what parameter you have to use to connect 2 controradola ZD3000 a reduntaste are. I have a ZD3000, working with several connected APs and want to put another controradola ZD3000 in Feilover with more AP. What is the best option for configutrar? Thank you.
4 REPLIES 4

tufail_ahmed
New Contributor
Hi Dreyes,


To have a Redundant setup, please enable Smart Redundancy.

Here are the steps how the feature can be enabled:

1: Login to the Zone Director.

2: Click on Configure >> System >> Check Enable Smart Redundancy.

3: Enter the Peer Device IP Address(Your Standby ZD IP Address)

4: Enter a Shared Secret(Password).

5: Login to the Secondary Zone Director follow the Step 2 to 4.


This will enable a Smart Redundancy on your Setup.

You can also refer to this article , if you have Active support:

https://support.ruckuswireless.com/an...

Thank you. Tufail

At the time of setting the 2nd ZD3000 in feilover she takes the configuration gives the first?
I have to do a backup to primary and subirselo which will be in Feilover?

In conclusion I have a ZD3000, with 150 APs connected and I will connect 75 new license and one with ZD3000, to be set to Feilover.

michael_brado
Esteemed Contributor II
If you have 150 APs, both ZDs need licenses to be able to manage 150 APs, in case one was offline.

When working as Active/Standby peers, yes, the configuration is synchronized between both ZDs.

All APs will be managed by the Active ZD, until/unless a failover is triggered by the administrator or network problem.