cancel
Showing results for 
Search instead for 
Did you mean: 

Troubleshooting LWAPP packets

kevin_tyler_685
New Contributor II
How do I access the LWAPP packets in order to troubleshoot ZD /AP connectivity issues?
3 REPLIES 3

michael_brado
Esteemed Contributor II
A switch port trace of either ZD or AP port will provide all the necessary information.

If trying to bring up new APs, confirm you have routing between the AP and ZD,
and you may need a DHCP option 43 or DNS 'zonedirector' hostname defined
with your ZD's IP address. If there is network connectivity but AP isn't seen trying
to connect, you can also SSH to your AP and give the CLI command 'set director
ip a.b.c.d' where a.b.c.d is your ZD's IP address, followed by 'reboot'. After the
reboot, the AP will send LWAPP discover to your ZD's a.b.c.d IP address.

If all else fails, open a ticket with Tech Support for further troubleshooting/assistance.

kevin_tyler_685
New Contributor II
Hi Michael,
Aren't the LWAPP packets within the tunnel? I know in the Cisco WLC-5508 you have to troubleshoot CAPWAP and LWAPP by enabling the LWAPP log messages within the controller. Is there a way to access the LWAPP messages within the ZD's log messages to troubleshoot the connection between the ZD and AP in more detail?

Thanks for your help

michael_brado
Esteemed Contributor II
Unfortunately, no, Ruckus does not have LWAPP exchange message analysis.
ZD Debug with 'Access Points' component will show some AP/ZD communication
exchange but does not decrypt LWAPP.

A Ruckus TSE can enable tcpdump from AP shell mode to see LWAPP, but this
is not something available to users, without opening a Tech Support ticket.
Labels