I recently update the firmware on my ZoneDirector 1200 (To software version 220.127.116.11.216) and after a reboot the device has become completely unresponsive. I tried move it to a new VLAN, to see if it would obtain an IP address and nothing. Tried multiple reboots, even leaving disconnected overnight, but still nothing. So I have tried holding down the RESET button and still no change.
Right now I have steady (not flashing) lights for both status and power and, if I plug in an Ethernet cable, both lights come on and stay solid (again not flashing to show activity). I checked my DHCP log and it is not trying to obtain an address either.
I have connected a console cable RJ45 to serial to USB (which I have used on many other devices without problems and even plugged it into another wireless device to check it is still working), but I get nothing on my putty screen either.
At this stage I have to presume that the device is completely dead, however I am open to any suggestions as to what I should do at this stage - The device is still under warranty, therefore returning it for repair is an option, but it is powering a phone (via two R600's and MESH) in our pool area and I need this running ASAP now summer water-polo season has started (major liability not have any form of communication at the pool).
Thanks in advance