cancel
Showing results for 
Search instead for 
Did you mean: 

Cannot get R510 to Join VLAN from ZD1200

steve_hensyel
New Contributor

I am trying to add a new R510 AP to a ZD1200 and cannot get it to see VLAN 2. 

The current APls that are on there and configured and working show VLAN 2 under their info page. (They are T300 and R500). 

The ZD1200 sees the new R510 AP and says it is connected and has an IP of 10.34.14.74

The switch port for the new ap are 2UP and the ZD1200 can see it. If I change this to the same port settings as the other AP's then the ZD1200 cannot see it. 

The new AP shows    VLAN 2 10:f0:68:3e:6d:40 GE1/19 in the switch MAC addr table

The working AP's have a switch port with 2T, 14UP, 60T, 70T. 

Pic of AP T300 showing VLAN 2

VLAn 2 T300.jpg

Pic of R510 showing VLAN 1

vlan1 model 510.jpg

1 REPLY 1

syamantakomer
Community Admin
Community Admin

Hi Steve,

Looks like configuration issue.

Could you check below configuration.

  1. Check what the VLAN set for AP management in ZD.
  2. Make sure same set of VLANs are allowed on switch port trunk.
  3. Make sure AP eth port is set to Trunk, not access. 
    1. get interface eth0

Syamantak Omer
Sr.Staff TSE | CWNA | CCNA | RCWA | RASZA | RICXI
RUCKUS Networks, CommScope!
Follow me on LinkedIn