10-07-2021 08:15 PM
if an ap shows the RSSI value of a client is greater than 75dbm， which means signal very bad .
I dont know ruckus production very much , but i want to know how to kill the bad signal client offline , and then make sure that the client can connet the nearest ap when the movable client change its location .
How to set the ZD1200 , which can automatically implements the function .
10-07-2021 08:16 PM
it can be used SNR value to represent the signal too
10-08-2021 03:03 AM
I think you mean -75dbm of RSSI. That's still a good value for the signal, bad values would be -90 dbm or less but It would also depend on the noise and interference of the surrounding environment and even for the type of service (voice, video, data, etc.). A better measure is the Signal to Noise Ratio (SNR) which should be above 25 to have a good connection. On how to remove these clients, once they are offline they should be gone after some minutes when ZD refresh data.
10-08-2021 03:16 AM
@david_saez thank you your answer.
i saw some cases after i posted this question.
right now i know how to tune the zd1200.
here are my set:
SmartRoam Factor is set 5,
and BSS Min Rate is set 12mbps.
what do you think.
10-08-2021 03:51 AM
SmartRoam factor to 5 will make clients roam when SNR(also shown as RSSI) is bellow 20, so It is a good value to roam.
BSS Min Rate is good to 12 too.