r500 unleashed reboot loop Rebuilding the Unleashed Network. It may take a few minutes

[beau_murray]

I have 4 x r500 in an unleashed network which are working wonderfully

I have since tried to add an additional 4 but none will join. They simple state

"Rebuilding the Unleashed Network. It may take a few minutes. WARNING - Do not power off or reboot the AP. - Do not refresh your browser or hit the browser's back button."

I note the mac addresses on the original units start with f0:3e. I note the mac address for these new units start with  0c:f4. This may mean nothing but find it strange the vendor ID's are different

I factory defaulted the new units but still the same problem, it’s a layer 2 network and I have attached these to different/same switches. Again, the old ones worked fine when growing the network.

I have upgraded the new unit to 200.3.9.13.228 manually but the same issue occurs,

I then tried upgrading my current working 4 AP’s starting with the master to from 200.1.9.12.55 to 200.3.9.13.228, now its in the same reboot loop.