connect Ruckus R320 with Cisco switch
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
05-15-2020 02:22 AM
I have Ruckus R320 and I connect it with Cisco switch, but it not connect, so in Cisco switch I need add management vlan ?
my config in Cisco:
"switchport trunk allowed vlan 2,10,15,30,205
switchport trunk native vlan 999
switchport mode trunk
switchport nonegotiate"
management vlan is 205.
Thanks a lot!
my config in Cisco:
"switchport trunk allowed vlan 2,10,15,30,205
switchport trunk native vlan 999
switchport mode trunk
switchport nonegotiate"
management vlan is 205.
Thanks a lot!
9 REPLIES 9
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
05-15-2020 02:25 AM
Hi Nguyen,
Can you please let us know from which Vlan you want the Ap to get an ip address from. Is it 999 or 205.
When the AP is connected to switch it will try to get ip address from Native Vlan.
Regards,
Arun N
Can you please let us know from which Vlan you want the Ap to get an ip address from. Is it 999 or 205.
When the AP is connected to switch it will try to get ip address from Native Vlan.
Regards,
Arun N
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
05-15-2020 02:29 AM
I want AP get IP from vlan 205, that is vlan management.
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
05-15-2020 03:02 AM
Hi Nguyen,
Do you have any SZ/vSZ in the network to manage this R320 Ap or is it running as a standalone AP.
Regards,
Arun N
Do you have any SZ/vSZ in the network to manage this R320 Ap or is it running as a standalone AP.
Regards,
Arun N
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
05-15-2020 03:20 AM
Hi Nguyen,
If the AP is running as standalone.
Please connect the Ap directly to your laptop and access the AP with its default Ip address 192.168.0.1. Login to Ap CLI using default username and password. Once you login, you can use the below command to check the Vlan and then connect it to the cisco switch.
set ipaddr wan vlan
Regards,
Arun N
If the AP is running as standalone.
Please connect the Ap directly to your laptop and access the AP with its default Ip address 192.168.0.1. Login to Ap CLI using default username and password. Once you login, you can use the below command to check the Vlan and then connect it to the cisco switch.
set ipaddr wan vlan
Regards,
Arun N

