Smart Roam on Unleashed AP's

[jason_santlofer]

Anyone Use Smart Roam on an Unleashed Network? Is it in a firware revision? I can't seem to find the option. On Zone Director networks it was always just a checkbox.

[monnat_systems]

its there in version 200.5.10.0.291

[jacky_yeung]

Our firmware is 200.5.10.0.291
and it had smart roam command.

[jesper_bach1]

Like this in 200.5. ssh to your current master AP. Configure per SSID.
Start testing conservatively with a roaming factor of 2-3, keep SSID using one frequency only (2.4/5GHz) or AP will switch to 2.4GHz when 5GHz cannot reach.

ruckus(config)# wlan MyWiFi

The WLAN service 'MyWiFi' has been loaded. To save the WLAN service, type 'end' or 'exit'.

ruckus(config-wlan)# smart-roam

         Enter the roam factor(1-10) or keep it empty.

ruckus(config-wlan)# smart-roam 5

ruckus(config-wlan)#exit 

Expect to se ‘disconnected by [xxxx] from WLAN[yyyy]’  in the log, when the Smart-Roaming function is activated. This you can also find on Ruckus Support.

[hayward_kong]

You can also check out smart roaming feature....not sure it’s in unleashed GUI yet, but it should be in CLI.

check out this,discussion..
 https://forums.ruckuswireless.com/ruckuswireless/topics/smart-roam-on-unleashed-aps

[sanjay_kumar]

Hi Jacky,

While configuring the Smartroam, "Smart-roam" parameter takes values from 1 to 10.
These are called roam factor, and they map to a RSSI value in dB as per the list below:



A client will disconnect if it's signal falls below user definable threshold (Lower RSSI) as per table).