Show Commands on Rukus AP

[kasonde]

I would like to know the commands to show configs on an AP, 

I would like to know the status on HTTP and HTTPs status  from cli.

Whats the command for that??

[Vásquez_Fer]

Hello  kasonde

To know the status of https and http are get https and get http

Here are the commands to run in a Master Access Points 

ruckus> enable
ruckus# ap-mode
You have all rights in this mode.

ruckus(ap-mode)# get https
HTTPs access is enabled
But the service is off, it is turned off to save memory once AP is managed by SCG!
If you need the service, please enable again by command "set https/http enable"!
OK
ruckus(ap-mode)# get http
HTTP access is disabled

If you need to verify on a Member access please do the command directly

rkscli:get https

Best Regards 

Fernando Vasquez