Running Unleashed 200.18.x with auto-channel at 80MHz.

[Devinator]

Running Unleashed 200.18.x with auto-channel at 80MHz. I'm noticing that the system is selecting any of the four 20MHz channels as the primary, which has the potential for P/S OBSS interference. Is there a way to configure Unleashed (UI or CLI) to only use the lowest channel numbers as primary when using wide channels?

[Devinator]

Ruckus is using the second channel in each 80MHz set (PSC) on 6GHz as the primary, which is very good. Happy to see them doing this, and it doesn't need changing. However, on 5GHz, they should always be using the lowest channel in the set as the primary, and I cannot figure out how to tell the Unleashed system to do that.

[gritech]

80MHz can change the channel width per frame.  Using all 4 20MHz as primary is standard gives you 4 non-interfering primary channels and each frame will use the 20, 40, or 80 depending on other traffic at the moment.