cancel
Showing results for 
Search instead for 
Did you mean: 

Ruckus Unleashed's AP Conflict Handling

jacky_wing
New Contributor

If I have a running unleashed wifi config with R510 (CONFIG A), and suddenly I plug an AP (either master or member) from another running network (CONFIG B) into same LAN

a. will the configuration (CONFIG B) of the new added AP being overwritten with the running config (CONFIG A)?

b. are there any chance for conflict? e.g. make existing member APs switch from using CONFIG A to CONFIG B?

c. it is a good practice to reserve IP address for all APs?

3 REPLIES 3

Anonymous
Not applicable

Hi Jacky_Wing,

As per the design, every time unleashed AP (irrespective of roles) is booted up, it searches for available master APs in the same network. If yes, then the AP would join the existing Master AP, else the AP will decide itself as a Master AP and wait for member APs to join.

In your scenario, Config-A would override the new AP config. 

C. It is a good practice to reserve IP address for all APs?

We never noticed any potential impact reserving IP address in DHCP. Should be good practice.

Hi, thanks for your fast reply!

In case of accidentally isoladted network and now two WIFI configurations are both running in the same network, when they see each other later, what will happen? Will they try to compete and make other AP to use the same config?

Anonymous
Not applicable

In that case Master APs will stay up and maintain it's own configuration until it's rebooted. However, we cannot guarantee the member APs, they might switch back and forth between two Masters, inheriting the current master config.

Regards,

Parikshith