cancel
Showing results for 
Search instead for 
Did you mean: 

Reset factory R500 unleashed

s_bastien_cadet
New Contributor
Hi,

I have 2 Ruckus Unleashed R500 version 200.4.9.13.47.
After doing a reset factory (I push reset button over than 12s), I can't connect web interface (https://[IP_ADDRESS] or http://[IP_ADDRESS]).

Then :
- Ping to these addresses is OK
- I have no SSID "ConfigureMe.xxx"
- Connection to SSH is OK but default login/password don't work

What's wrong ? Any idea ?

Regards
6 REPLIES 6

michael_brado
Esteemed Contributor II
Hi,
     Take one AP and Ethernet connect it to your PC, and do the AP factory default again. 
Set your PC's IP to 192.168.0.10 (anything except .1).  Try WebUI to 192.168.0.1 and use
'super' / 'sp-admin' login credentials.  If you get logged in, you can tell just what version of
firmware is running on the AP(s), or if you get an Unleashed network initiation page.

s_bastien_cadet
New Contributor
Hi,

I tested your solution with my 2 Ruckus R500 unleashed but no page is displayed (http and https).
I did a factory reset again but nothing changed.

Regards.

dmytro_savin
New Contributor II
What is username/password afrer factory reset . Super/sp-admin does not work for unleashed firmware

Do the access points have a username and password printed on the back under the default ip address.