cancel
Showing results for 
Search instead for 
Did you mean: 

R650 shows stead power, CTL flashing - nothing else?

bdillard
Contributor II

Hello,

 

I have an R650 (I got used).   Usually I just reset them to factory defaults, flash them then configure them.   This one powers up with the power light, the CTL flashes slowly and the rest of the lights remain off.  I've tried pressing the power button for 7 seconds, 10 seconds, 20 seconds and even 30 seconds but it doesn't seem to reset even though it does reboot.

 

It isn't getting a DHCP address.

 

Other than returning it - any suggestions?

1 ACCEPTED SOLUTION

Hi @bdillard 

Based on the colors lights, since the CTL was blinking slowly, it looks like it was having trouble connecting to the Master AP.

https://docs.commscope.com/bundle/unleashed-200.9-onlinehelp/page/GUID-19D4261B-D10B-4DE3-B63A-3498F...

 

Best Regards

Fernando Vasquez 

View solution in original post

4 REPLIES 4

bdillard
Contributor II

I'm not sure but after about 8 resets, it finally got an IP and I was able to flash it.

 

Hi @bdillard 

Based on the colors lights, since the CTL was blinking slowly, it looks like it was having trouble connecting to the Master AP.

https://docs.commscope.com/bundle/unleashed-200.9-onlinehelp/page/GUID-19D4261B-D10B-4DE3-B63A-3498F...

 

Best Regards

Fernando Vasquez 

bdillard
Contributor II

Thanks - I ended up having to reset it many many times but eventuall it got an IP and I was able to flash it.

Great ! 

Best Regards

Fernando Vasquez