CommScope RUCKUS Community Forums

Rucky860 · ‎12-11-2023

The other day I ran the following commands on my R650s with Unleashed 200.14.6.1.203:

enable
ap-mode
set qos igmp_query v2 enable
set qos igmp_query v3 enable
set qos mld_query v1 enable
set qos mld_query v2 enable
set qos eth0 mld enable
set qos eth1 mld enable
set qos eth0 directed multicast disable
set qos eth1 directed multicast disable
set qos directedRA disable
set qos directedDHCP disable
set qos forward_querier enable
quit

After both APs are rebooted, the following settings are NOT persisted:

get qos:

IGMP General Query V2/V3: Disabled/Disabled
MLD General Query V1/N2: Disabled/Disabled

get qos eth0/eth1:

Directed Multicast: Enabled

MID Snooping Mode: Disabled

sanjay_kumar · ‎01-05-2024

Hi @Rucky860

I found the reason, the config changes which you are making is from the "ap-mode" which is not exactly the Master CLI mode but the AP CLI mode.
After making the changes, it will hold the config, but in fact it will saved as AP config and not in Master config. To save the config in the Master the settings as to be from the "Config" mode rather than the "Ap-mode".

So once the AP reboots, the AP config will override based on the Master config. Which is why the settings made from the ap-mode prompt is not saving.

View solution in original post

Rucky860 · ‎12-13-2023

Bump.

Rucky860 · ‎12-20-2023

This issue is very repeatable. I power cycled both R650s and some QoS settings (in original post) are lost. This clearly seems to be a bug. Can someone from Ruckus comment?

Rucky860 · ‎12-20-2023

@8vin Any thoughts?

Rucky860 · ‎12-30-2023

Can anyone help here? Seems like broken firmware.

CommScope RUCKUS Community Forums

QoS Settings not persisting across reboots