We have an internal network (networkA) with 9 r610s running in Unleashed mode. We have mesh enabled to connect a couple APs in the shop without physical wire. We want to add another r610 on a separate network (networkB). I took the AP offsite and connected it to a test network with the same subnet as the networkB. I configured it and left mesh disabled ( I was unsure whether it would re-configure itself through the mesh). When I power it up while connected to networkB at the office, it just sits at building unleashed network forever. I tried resetting it to factory while connected to networkB, and it does the same thing. It never creates the wireless setup SSID. If I take it offsite, it works fine. Is it not possible to setup a second wireless network on a separate LAN while in wireless range of the first?
