Hi all! I've got a problem. So I have three T300 (Firmware: 200.2.19....) and and two of them can't join the unleashed network (master one). They are in a loop... There's standing : Founding the Unleashed Network. It may take a few minutes. When it's finished, the browser can't build a connection up to the server and when I refresh the page it starts trying to join again but its not working.
So I tried to reset the AP's via SSH and put another Firmware on it. (220.127.116.11), with that one it's also not working.
I had a similar problem when adding a T300 to an existing Unleashed network running 200.2. In my case resetting the AP using the reset button worked, but you would figure that would do the same as a reset via SSH.
In your case, it might be worth ruling out any wired infrastructure issues then running a Wireshark trace to see if that gives any clues. Failing that, log a case with Ruckus.
Correct, best practice for one/an AP not joining the upgraded Unleashed network.
Try power cycle (soft reboot), and if not successful, a Factory Default (hard reset indented button for 8 sec before release), or... by CLI if you can SSH to the AP, 'set factory', and 'reboot'. Or thirdly if no luck, to contact TS. Thanks Michael.