How to stop APs in unleashed network from automatically turning off?

[epicurean]

After updating the firmware in my unleashed network ( 3x R610 and 1 x H510) to the latest 200.13.6.319, the 3 R610 have intermittenly been turnining on and off.  Previously, my master AP WIFI is usually off, and so is the H510 WIFI,and the WIFI coverage is great with just the 2 R610 (attic and ground floor). The master AP is on the 2nd floor, and the H510 is in the masterbedroom -on the 2nd floor as well.

Now the R610 in the attic does not come back on, and the H510 takes on a lot more clients on WIFI and the R610 on the ground floor comes on and off. How do I revert back to the original AP arrangement or at least prevent the Attic and Ground floor APs from being turned off?

Thank you

[Squozen]

Check your CAM table on the switch, it really sounds to me like you have an IP conflict.

[epicurean]

CAM table?

[Squozen]

Crap, I need coffee. I meant ARP table on your router. What router are you using?

[epicurean]

ICX6450-48P

Until this firmware upgrade, I never had such issues

[Squozen]

The 6450 is a switch, not a router. What's your router? What does the switch plug into? That's where you want to check which MAC addresses are using each IP.

You may have always had a bad configuration, but restarting devices has revealed the problem.