cancel
Showing results for 
Search instead for 
Did you mean: 

Configure port on Ruckus WAP R500 for alternate VLAN in Unleashed UI

lanmastermark
New Contributor II

I have a Ruckus R500 WAP. I'm using the wired network port on the device for a computer, but I want the computer to be on a different VLAN from the Ruckus device. I recall in the pre-Unleased UI there was a way to do this, but there is not within the Unleased UI. Can I do this via the command line, or can it be added to the Unleashed UI? Please advise. Thanks!

6 REPLIES 6

syamantakomer
Moderator
Moderator

Hi Ian,

What is the software version on your Unleashed setup?

AP port access VLAN configuration was not part of the old versions but if you can confirm the current version, I will check once.

Regards,
Syamantak Omer
Official Rep | Staff TSE | CWNA | CCNA | RASZA | RICXI

lanmastermark
New Contributor II

I believe I'm running the latest version for my WAP devices,

Current firmware version:  200.7.10.202.127

Thank you.

syamantakomer
Moderator
Moderator

Hi Ian,

AP port configuration option is not available on 200.7 version. Though it is supported on the latest version 200.10.

Refer the doc link below for 200.10.

https://docs.commscope.com/bundle/unleashed-200.10-onlinehelp/page/GUID-64C2EDE6-426A-4393-A9EA-940F...

Regards,
Syamantak Omer
Official Rep | Staff TSE | CWNA | CCNA | RASZA | RICXI

lanmastermark
New Contributor II

The document indicates that this feature is only available for the H320 and H510 models. My access points are model R500. Can you tell me if 200.10 will be available for this model anytime soon?