cancel
Showing results for 
Search instead for 
Did you mean: 

upgrade firmware via tftp in mm2211

sahil_p
New Contributor II
i want to upgrade firmware via tftp in mm2211. but i am not getting the reply from the routers gateway. also i am not able to open the default login page of the router, so i have gone through a few websites and would like to know the following.

1) where is the jtag port on 2211.
2) where is the serial port on 2211.
3) does anyone have a step by step guide on how to connect a serial console to 2211 and then do a tftp and flash the original firmware.

thanks

please note that i have tried every type of reset from holding down the reset button to 30-30-30 reset and so on but nothing works.
5 REPLIES 5

michael_brado
Esteemed Contributor II
Use a paper clip and press the indented Hard Reset button to the far right of the back of the mm2211.

If you hard code your PC with an IP address in 192.168.30.x/24 subnet, you should be able to ping/HTTP
to the mm2211's 192.168.30.1 address.

If you cannot access the default login page of the mm2211, you likely have an ISP model, OEM'd from Ruckus
which we cannot alter/modify.

sahil_p
New Contributor II
thanks for your reply but i tried its not working, thats because when i inserted a pin it was not giving me any kind of resistance or a feedback of a button. so i opened my unit to check inside and found that the reset button was bent, maybe some one in my family tried it too hard, and as i tried to bring it back to its normal position, it broke. 
 and when i connect it to a pc. it connects quickly but doesnt assign a gateway to the pc. 
if it assign a gateway i can ping it, but after multiple ipconfig commands there is no gateway. 

the only solution is  a serial way or a jtag method, can you assist in either of these.
most probably i would like to go with serial console method.
thanks

sahil_p
New Contributor II
also please note that the router is in perfectly working condition. its juts that i am not able to access the administration page.
thanks

sahil_p
New Contributor II
and on this community is there any way wherein i can send a personal message to any other member or  a personal message to you Michael?