Mesh configuration on Zone Director 1200 and T300 Outdoor units

[mwaula_solopi]

Hello,  how to configure outdoor Mesh Networking topology configuration. I have a ZoneDirector 1200 and 10, T300 outdoor units. The zone director is connected on the LAN and mesh configuration is enabled. I am able to view (monitor) the connected T300 units to the same LAN using the Ethernet cables, however, once I disconnect the Ethernet cables from some units, these outdoor units fail to connect (mesh)with the other T300 units connected to the LAN via Ethernet cables. Help will be highly appreciated...
thnx

[mwaula_solopi]

Hello,

Well, the Version firmware is 9.9.0.0 build 216 and meshing still does not happen even when the root and mesh AP are on the same table........so will try to update the firmware then observe what goes yaa..

[monnat_systems]

pls upgrade to latest firmware for controller and then try again...
please read release notes for correct upgrade path and you will have to upgrade many times to reach latest firmware... if still in doubt then better contact support for more info...