All set up -- but a couple of questions

[jason_sparrow]

Well, I have just set up my r600's in the house, and I cannot believe how easy it was, even via the web host!

Now that's all done, I have noticed that some devices appear to be connected to both ap's at the same time. I have tried tweaking the power settings etc but they still seem to hang on. Is there anything else I have missed that I should try?

Also, is there a way of renaming each device in the list rather than having to guess what the ip/mac address is?

Thanks!

[john_d]

Totally personal preference. I just use DHCP because I rarely need to access my AP's, and don't mind checking the DHCP lease table on my firewall/gateway to figure out their IP's.

[jason_sparrow]

ok i have set them up with static for now so ill leave them for now.

Which software would i need to upgrade?

There is a zoneflex one and a Standalone so im not sure which? or both?

https://support.ruckuswireless.com/products/69-zoneflex-r600#firmwares

[seanmuir]

The base 100 images (stand alone images) have only been created to allow the AP to join both the SCG and the ZD. On a stand alone AP you can use what you want really as they all have the same capabilities.

[jason_sparrow]

Ok thanks.

I have just downloaded the base 100 file, so do i just unzip it and select the unzipped file in the option in the local upgrade?

And lastly, should i do the upgrades in order of release or can i just jump straight to the latest version?

🙂

[seanmuir]

As they are stand alone AP's there is no rule of upgrading firmware - this applies ot bothe the base 100 and xoneflex images.

If you were to move to a ZD however, there are upgrade paths and these are mentioned in the release notes of each firmware release.