cancel
Showing results for 
Search instead for 
Did you mean: 

ICX6610 invalid input when trying to creating ve interface

hasan_shukri_za
New Contributor
I'm getting the error invalid input when trying to create ve interface. Is there any changes in command for creating this ve interface? or need to enable certain features first. please help me.
4 REPLIES 4

david_ellis_h2n
New Contributor II
The first obvious question is are you running routing code?

BenBeck
Moderator
Moderator
You also need at least one port in the vlan.

Example:

conf t
vlan 10
untagged eth 1/1/1
router-interface ve 10
interface ve 10
ip address x.x.x.x/x
Ben Beck, RCNA, Principal Technical Support Engineer
support.ruckuswireless.com/contact-us

chris_hill_4zpl
New Contributor III
It was answered in your other thread about this topic - you are running a layer 2 firmware on that 6610. You need the layer 3 firmware to allow the layer 3 interface. 

Example filename for routing firmware: SWR08030h.bin (the 'R' in the 3rd position indicates routing)

pissed_off_g4li
New Contributor
I've got the same issue.  Using a legacy layer 3 switch GFS648POE.  configuration guide says it should be capable of layer 3 ip routing between vlans, but none of the layer three base level commands seem to work.  The unit was purchased surplus with 7.2.02g firmware on it.  What do I need to make it layer 3 aware?