ZF7982 standalone mode - can not use Google Chromecast

[hieu_le]

I am using ZF7982, standalone mode and facing this issue: when i use Google Chromecast to cast from my laptop to my home TV, the video casting on TV is lagged, unable to watch. I didnt get this issue when used ASUS NT-R12. 
I wonder if any special setting on ZF7982 for casting service?

[syamantakomer]

Hi Hieu,

Could you confirm the software version running on the AP and what are the WLAN settings?

Also confirm if casting is lagged or not at all showing the feed.

Try disabling directed multicast option and see if that helps.

There is a similar post you can refer for the commands related to directed multicast.

https://forums.ruckuswireless.com/conversations/access-points/strange-issue-with-zoneflex-7363/6182c...

[hieu_le]

@syamantak_omer 

The current sofware running on the AP is 9.6.1.0.15 which recommended by Ruckus.

The WLAN settings as enclosed. The casting is lagged. In additional, when i use wired cable connected to Google Chromecast, there isnt any issue so i do believe that something wrong with WLAN setting, not multicast/ unicast option.

[syamantakomer]

@hieu_le WLAN configuration is standard so I do not find any issue with basic configuration.

9.x is very old and ZD firmware code, try below software version and see if it makes any difference.

https://support.ruckuswireless.com/software_downloads/1017-zoneflex-solo-access-point-104-0-0-0-1347...

You can also try 100.1.0.0.432

https://support.ruckuswireless.com/software_terms_and_conditions/838-ruckus-zoneflex-solo-indoor-acc...

[hieu_le]

@syamantak_omer 

Actually i tried with both 100 & 104 but it even worse than 9x 🙂