AP firmware 3.6.0.0.709 High Connection Errors

[Anonymous]

I have upgraded my Vsz to 3.6.0.0.510 and upgraded the APs to 3.6.0.0.709.  After the upgrade i noticed that almost every AP had a high percentage of connection errors.  I let it go for several days and thought i still had a lot of clients connected so it must be working.  In the events I see a lot of Force DHCP disconnects.  I did not make any changes to that but did double check the settings.  Some wlans were not enabled and some set to anywhere from 5-15 seconds.  Downgraded the firmware to 3.5.1.0.1026 and the connection errors went away.  Has anyone seen this and have any ideas why i am seeing this.  

[Anonymous]

I am seeing he same type of stats. User experience seems good but the stats are a bit concerning.

[Anonymous]

We also see the same, before 3.6 only a few (VHD areas) APs showed anthing above 2% -- now almost all have 70%+. Definitely a bug.

[Anonymous]

Wonder if its a stats/counting error or real connection troubles. The user experience seems to be fine so far, but this was a brand new deployment starting on 3.6 so I don't have a reference point.

[Anonymous]

If you go to the AP and then down to Event tab - type in "authenticat" in the search, are there alerts/errors present?

[Anonymous]

No authentication or connection errors on the event log. In fact, the main network is not even protected (its just an open network). I will look at stats per SSID