ICX 7150 - Always down after power outage. Manual reset no longer working

[kcrum22]

Hello. 

My switch always stops working after a power outage. I have previously been able to manually reset via direct connect with Putty. That is no longer working. I assume I need to load in new boot/image files but I have not been able to successfully do so via the instructions in older forum posts. Looking for any help I can get....

[Imran_ruckus]

Hi @kcrum22 

Greetings!!!

I trust this message finds you well.

I kindly request an update on the status of the issue so that we may proceed further with resolving it.

Thank you.

Best regards,
Imran Sanadi
RUCKUS Lennar Home Community

[Imran_ruckus]

Hi @kcrum22 

Greetings!!!

I trust this message finds you well.

I kindly request an update on the status of the issue so that we may proceed further with resolving it.

Thank you.

Best regards,
Imran Sanadi
RUCKUS Lennar Home Community

[Imran_ruckus]

Hi @kcrum22 

Greetings!!!

I trust this message finds you well.

I kindly request an update on the status of the issue so that we may proceed further with resolving it.

If we do not receive a response from you within 24 hours from the timestamp of this message, your case will proceed to closure.

Thank you.

Best regards,
Imran Sanadi
RUCKUS Lennar Home Community