cancel
Showing results for 
Search instead for 
Did you mean: 

Can't find my network after completing the setup wizard

carli_morss
New Contributor III
After completing the Ruckus set up wizard, I finally come to the "Congratulations" screen. Once I clicked "Finish" I still cannot seem to find the network that I JUST set up. Please help!
32 REPLIES 32

Green Blinking Power LED on unleashed (and most Ruckus AP's) indicates the AP has booted but is not getting an IP via DHCP.

https://support.ruckuswireless.com/documents/3123-ruckus-unleashed-200-8-ga-user-guide

Is the AP plugged into a network that provided DHCP from a router or gateway?

Have you tried opening a browser to the default IP of the AP

If the wizzard has completed then the AP should also respond to url:

unleashed.ruckuswireless.com



carli_morss
New Contributor III
Was able to go through the ENTIRE setup wizard again. Still cannot find my network that I just created.

carli_morss
New Contributor III
@Albertpierson
HELP

hayward_kong
Contributor III
hmm very odd.. when you went through the setup did you notice what firmware version it was on?
...

Went through chrome, chrome canary, and safari.