We have a legacy system that we need to keep running a while longer with a ZD 3000 and outdoor mesh that should be upgraded from 9.6.2. to 9.7.2.
When you download 9.7.2 firmware from Ruckus there is a disclaimer to the effect that ZD and the APs will periodically connect to Ruckus to report serial numbers, support status, etc.
In our case everything runs on a private subnet that won't by default allow outbound communication with Ruckus. My question is, given this, will the software otherwise function normally? Or is the reporting required for ZD to work with 7.6.2?
Anusha, When I attempted this, ZD successfully upgraded to 188.8.131.52.20 but then none of the APs were able to upgrade and remained disconnected. ZD error message was "Failure to upgrade AP image ... after  retries"
All of my APs are 7762s but I noticed that there is no 184.108.40.206.20 firmware available for the APs, assuming that manually upgrading each would help.
Any suggestions as to why the APs would not upgrade? I tried factory reset on and individual AP, power cycling and deleting from ZD but still had the same result.
Fortunately I was able to restore to 220.127.116.11.13 but would still like to upgrade. thanks