This website uses cookies. By clicking Accept, you consent to the use of cookies. Click Here to learn more about how we use cookies.
Accept
Reject

 

RUCKUS Community Forums are now in READ-ONLY mode while we migrate to a new platform.

You will still be able to read posts and knowledge articles, but will be unable to post new content until Go Live on the new platform Monday August 17.

Lennar Smart Home customers: please contact [email protected] for assistance during the week of August 9-17.

 

Ruckus Wireless
RUCKUS Self Help |   ASK the Pack
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 

How can i enable SNMP for the APs in the Cloudcontroller?

Go to solution
Anonymous
Not applicable

‎12-12-2016 01:28 AM

I have to enable SNMP for the APs in our Cloud Controller, but i cant find the Setting for this. Ping is working, but SNMP request not, so i think its disabled. Since the Firmware 200.1.9.12.62 MR SNMP is supported for Unleashed APs, so it should work.

Someone who can help me?

Regards Dennis
Reply
1 ACCEPTED SOLUTION

Go to solution
vasanth_edward
Contributor III
In response to Anonymous

‎10-03-2023 06:42 AM

Hi @Anonymous, @jamesrucker,

Thank you for writing to RUCKUS Support via FORUM.

 

SNMP can be enabled from RUCKUS ONE now. However, APs support SNMPv2 and SNMPv3 in read-only operation.

Please refer User Guide https://support.ruckuswireless.com/documents/4481-ruckus-one-online-help-user-guide page 549 & 551 to configure SNMP agent profile & page 210 for enabling in individual AP.

MIB files can be download from https://support.ruckuswireless.com/software/3303-smartzone-6-1-0-0-935-ga-snmp-mibs-for-access-point...

For SNMP OID refer SNMP reference guide, can be downloaded from https://support.ruckuswireless.com/documents/4373-smartzone-6-1-1-lt-ga-snmp-reference-guide-sz100-v...

Do let us know should you have any further queries.

Regards,

Vasanth Edward

View solution in original post

0 Kudos
Reply
20 REPLIES 20

Go to solution
jbrown
New Contributor

‎10-03-2023 07:21 AM

FYI - some consumer-grade SNMP agents, like Domotz or OvrC require you fill out 2 entries for read-only and read-write. Since this implenetation is limited to read-only, just enter the same info for both communities. It works fine. OvrC only supports SNMPv2, and Domotz works with both v2 and v3.

0 Kudos
Reply
Copyright © 2026 Khoros, LLC