icx 7150 switch Change Boot Sequence

[nigelcov1]

I recently changed the boot sequence from primary to secondary in config mode. I am now unable to put it back to primary . When I try to change it back I get an error message " error-boot sequence has reached max 1 entries".

Any suggestions on how to accomplish this would be greatly appreciated.

Thanks!

[BenBeck]

You just need to remove the existing entry:

enable

conf t

no boot system flash secondary

wr mem

It will then default to primary again. 

[nigelcov1 · Accepted solution]

Thanks!    Worked perfectly.